Question 1

Question: Does the Hydro Shoot 80x80x178 cm grow tent allow the simultaneous installation of multiple heavy hanging equipment, and how can the weight distribution be optimized to ensure the stability of the steel structure?

Accepted Answer

The documented limit for Hydro Shoot HS80 V2 is 10 kg per bar · 20 kg total, distributed. Lamp watts and extractor m³/h do not indicate weight: add the masses of equipment, cables, hangers and accessories. Spread them across the intended bars without exceeding any limit. Do not hang a filled reservoir or use improvised reinforcement to increase capacity.

Question 2

Is a natural ventilation of 30x20 cm sufficient to prevent my plants from getting too hot in a small apartment during summer?

Accepted Answer

Hydro Shoot HS80 V2 has 2 sleeves Ø 180 mm. These are openings, not built-in fans. Arrange the inlet and exhaust so fresh air does not immediately leave again, and provide suitable circulation around the foliage. Size actual airflow with the filter, bends and duct length in mind; check temperature and humidity, including after lights switch off. Air renewal cannot cool the enclosure below incoming-air temperature. Manufacturer configuration reference: 200 m³/h extraction with a filter. This is a sizing example, not measured installed flow or a VPD guarantee; adapt it to actual equipment and climate.

Question 3

What is the best strategy to manage ventilation and humidity in the Hydro Shoot 80x80x178cm to maximize differential growth between the growth and flowering periods?

Accepted Answer

Hydro Shoot HS80 V2 has 2 sleeves Ø 180 mm. These are openings, not built-in fans. Arrange the inlet and exhaust so fresh air does not immediately leave again, and provide suitable circulation around the foliage. Size actual airflow with the filter, bends and duct length in mind; check temperature and humidity, including after lights switch off. Air renewal cannot cool the enclosure below incoming-air temperature. Manufacturer configuration reference: 200 m³/h extraction with a filter. This is a sizing example, not measured installed flow or a VPD guarantee; adapt it to actual equipment and climate.

Question 4

What is the heat management in the Hydro Shoot 80x80x178cm to avoid overheating with lighting over 320W?

Accepted Answer

For 80 × 80 cm, choose lighting by plant needs, its PPFD map at the intended height, dimensions and required clearances. Tent size alone does not establish a maximum wattage. Watts certify neither hanging capacity nor a stable temperature; add suspended masses and test heat with equipment running. Without a specific light and measurement protocol, no PPFD or g/W increase can be given.Hydro Shoot HS80 V2 has 2 sleeves Ø 180 mm. These are openings, not built-in fans. Arrange the inlet and exhaust so fresh air does not immediately leave again, and provide suitable circulation around the foliage. Size actual airflow with the filter, bends and duct length in mind; check temperature and humidity, including after lights switch off. Air renewal cannot cool the enclosure below incoming-air temperature. Manufacturer configuration reference: 200 m³/h extraction with a filter. This is a sizing example, not measured installed flow or a VPD guarantee; adapt it to actual equipment and climate.

Question 5

Is there a beginner kit compatible with the Hydro Shoot 80x80x178cm available? Is the assembly quick to do solo? How long does it take to see my first real shoots in this box?

Accepted Answer

Cover and frame, 2 hanging bars, 1 removable tray(s). Add lighting, extraction, air circulation, a filter if needed, pots and growing medium separately. An equipped illustration does not mean the devices are included. Check the offer contents before selecting a kit.The Hydro Shoot HS80 V2 manual sets out assembly order; no maximum time or solo assembly is guaranteed here. Sort parts, clear the work area and follow the frame diagram first. Open the required zips before fitting the cover without force, then check all joints. Get help for large models and remove all equipment before moving the tent. Plant growth depends on species and conditions, not assembly time.

Question 6

What is the best strategy to manage air circulation with the two 180 mm ventilation socks to optimize growth without risking excessive temperature or humidity in the Hydro Shoot 80x80x178 cm tent?

Accepted Answer

Hydro Shoot HS80 V2 has 2 sleeves Ø 180 mm. These are openings, not built-in fans. Arrange the inlet and exhaust so fresh air does not immediately leave again, and provide suitable circulation around the foliage. Size actual airflow with the filter, bends and duct length in mind; check temperature and humidity, including after lights switch off. Air renewal cannot cool the enclosure below incoming-air temperature. Manufacturer configuration reference: 200 m³/h extraction with a filter. This is a sizing example, not measured installed flow or a VPD guarantee; adapt it to actual equipment and climate.

Question 7

Beginner kit with Hydro Shoot 80x80x178 easy to install? Is it possible to suspend lamp and filter together without any issues? How long before seeing the first real results on the plants?

Accepted Answer

Cover and frame, 2 hanging bars, 1 removable tray(s). Add lighting, extraction, air circulation, a filter if needed, pots and growing medium separately. An equipped illustration does not mean the devices are included. Check the offer contents before selecting a kit.The documented limit for Hydro Shoot HS80 V2 is 10 kg per bar · 20 kg total, distributed. Lamp watts and extractor m³/h do not indicate weight: add the masses of equipment, cables, hangers and accessories. Spread them across the intended bars without exceeding any limit. Do not hang a filled reservoir or use improvised reinforcement to increase capacity.The Hydro Shoot HS80 V2 manual sets out assembly order; no maximum time or solo assembly is guaranteed here. Sort parts, clear the work area and follow the frame diagram first. Open the required zips before fitting the cover without force, then check all joints. Get help for large models and remove all equipment before moving the tent. Plant growth depends on species and conditions, not assembly time.

Question 8

What is the ideal setup to grow two crops in parallel in the Hydro Shoot 80x80x178cm in terms of lighting and air circulation?

Accepted Answer

Plants with compatible needs can share Hydro Shoot HS80 V2, but separate lights or timers do not create light- and air-isolated zones. Group plants by height, photoperiod and climate needs, leaving room for airflow. For truly different dark periods or climates, use purpose-designed separate enclosures or partitions with suitable ventilation; do not cut the cover to improvise two tents.

Question 9

What is the ideal ventilation to set up with the Hydro Shoot 80x80x178cm tent to avoid humidity and temperature problems?

Accepted Answer

Hydro Shoot HS80 V2 has 2 sleeves Ø 180 mm. These are openings, not built-in fans. Arrange the inlet and exhaust so fresh air does not immediately leave again, and provide suitable circulation around the foliage. Size actual airflow with the filter, bends and duct length in mind; check temperature and humidity, including after lights switch off. Air renewal cannot cool the enclosure below incoming-air temperature. Manufacturer configuration reference: 200 m³/h extraction with a filter. This is a sizing example, not measured installed flow or a VPD guarantee; adapt it to actual equipment and climate.

Question 10

Are the ventilation openings sufficient to maintain a good air exchange without the need for additional noisy fans?

Accepted Answer

Hydro Shoot HS80 V2 has 2 sleeves Ø 180 mm. These are openings, not built-in fans. Arrange the inlet and exhaust so fresh air does not immediately leave again, and provide suitable circulation around the foliage. Size actual airflow with the filter, bends and duct length in mind; check temperature and humidity, including after lights switch off. Air renewal cannot cool the enclosure below incoming-air temperature. Manufacturer configuration reference: 200 m³/h extraction with a filter. This is a sizing example, not measured installed flow or a VPD guarantee; adapt it to actual equipment and climate.

Question 11

Can you confirm if the Hydro Shoot 80x80x178cm allows for the installation of multiple plant varieties with different light requirements in the same tent, without affecting their respective growth?

Accepted Answer

Plants with compatible needs can share Hydro Shoot HS80 V2, but separate lights or timers do not create light- and air-isolated zones. Group plants by height, photoperiod and climate needs, leaving room for airflow. For truly different dark periods or climates, use purpose-designed separate enclosures or partitions with suitable ventilation; do not cut the cover to improvise two tents.

Question 12

Possible integration with connected sensors such as temperature and humidity for remote monitoring in the Hydro Shoot 80x80x178cm?

Accepted Answer

Hydro Shoot HS80 V2 is a passive enclosure: it has no built-in connected sensor, app or voice control. You can add mutually compatible sensors and controllers, use the intended cable openings and check wireless coverage. Control of lighting, extraction and irrigation depends on equipment interfaces, not the tent. WebIT is a plant support net, not a home-automation system.

Question 13

What is the best way to organize multiple varieties in the Hydro Shoot 80x80x178cm to optimize air circulation and light distribution without stressing the plants?

Accepted Answer

Plants with compatible needs can share Hydro Shoot HS80 V2, but separate lights or timers do not create light- and air-isolated zones. Group plants by height, photoperiod and climate needs, leaving room for airflow. For truly different dark periods or climates, use purpose-designed separate enclosures or partitions with suitable ventilation; do not cut the cover to improvise two tents.

Question 14

Is integration possible with a home automation system or connected sensors to monitor temperature and humidity remotely on the Hydro Shoot 80x80x178cm?

Accepted Answer

Hydro Shoot HS80 V2 is a passive enclosure: it has no built-in connected sensor, app or voice control. You can add mutually compatible sensors and controllers, use the intended cable openings and check wireless coverage. Control of lighting, extraction and irrigation depends on equipment interfaces, not the tent. WebIT is a plant support net, not a home-automation system.

Assembled dimensions	80 × 80 × 178 cm
Nominal footprint	0.64 m² nominal
Nominal volume	1.14 m³
Reflective fabric	Mylar M210D
Pole diameter	Ø 16 mm
Net weight	6.1 kg
Hanging load	10 kg per bar · 20 kg total, distributed
Ventilation openings	2 sleeves Ø 180 mm
Cable openings	1 × Ø 75 mm
Growing equipment	Add lighting, extraction, air circulation, a filter if needed, pots and growing medium separately.
Floor tray	1 removable tray(s)

Dimensions	80 × 80 × 178 cm
Growing area	0.64 m² (nominal footprint)
Weight (kg)	6.1
Mylar density	M210D
Hanging bars	2
Ventilation opening diameter (mm)	2 sleeves Ø 180 mm
Max load (kg)	20 (10 per bar)
Volume (m³)	1.14 m³ nominal

Secret Jardin Hydro Shoot HS80 V2 – grow tent 80 × 80 × 178 cm

Choose your model

2 packs including this product

Choose your pack

Complete kit 80x80 cm – Lumatek ATS 200 PRO + Hydro Shoot 80 + ventilation kit without carbon filter + pots and soil

Complete pack 80x80cm – SpectraWILD S320 - Hydroshoot 80 - Ventilation kit without carbon filter - Pots and soil

Product presentation

Your growing space.
0.64 m² of floor space.

80 × 80 cm: leave room for access.

What is included

What you need to add

Details that shape your setup

Reflective walls around the growing area

Air sleeves ready for ducting

An accessible base for cleaning

Assemble, equip, then check

Assemble the frame and cover

Position equipment with enough clearance

Test airflow with equipment running

Simple access for maintenance

Specifications: Hydro Shoot HS80 V2

A question about your setup?

A growing enclosure to equip for your plants.

Features detailed

Reviews customers

Très bon produit

Bluffé

Franchement, c'est du

Ça marche super

Franchement bluffé par ce

Très bon rapport

Bon produit, bon

Pas mal du

Franchement, c'est un excellent

Plutôt bon. Ça

Excellent choix. Ce produit

Your questions

Viewed recently

Write your review

Secret Jardin Hydro Shoot HS80 V2 – grow tent 80 × 80 × 178 cm

Choose your model

2 packs including this product

Product presentation

Your growing space.0.64 m² of floor space.

80 × 80 cm: leave room for access.

What is included

What you need to add

Details that shape your setup

Reflective walls around the growing area

Air sleeves ready for ducting

An accessible base for cleaning

Assemble, equip, then check

Assemble the frame and cover

Position equipment with enough clearance

Test airflow with equipment running

Simple access for maintenance

Specifications: Hydro Shoot HS80 V2

A question about your setup?

A growing enclosure to equip for your plants.

Features detailed

Reviews customers

Très bon produit

Bluffé

Franchement, c'est du

Ça marche super

Franchement bluffé par ce

Très bon rapport

Bon produit, bon

Pas mal du

Franchement, c'est un excellent

Plutôt bon. Ça

Excellent choix. Ce produit

Your questions

Viewed recently

More from Secret Jardin

Related articles

Write your review

Your growing space.
0.64 m² of floor space.