Cli-mate Temperature Controller Temp – heating or ventilation, 16 A

Cli-mate Temperature Controller 16 A
Up to 16 A continuous • Digital touch display • Settings memory • 5 m sensor

This controller switches a heater, fans or an air conditioner on and off according to measured temperature. It accepts up to 16 A in prolonged operation, making it capable of driving appliances far hungrier than a simple extractor.

What sets it apart: the 16 A. Most controllers in the range drive fans; this one also takes a heater or an air conditioner, with no extra relay.

Driving heating, not just ventilation

Regulating a grow room is not only about removing heat. In winter, or during the dark period, temperature can drop too low and slow growth. This controller drives either a device that warms or one that cools, depending on the mode selected.

A 5-metre sensor that changes the install

The 5-metre cable lets you place the unit where it is accessible — outside the space, near the socket — while measuring temperature exactly where it matters. That is what separates accurate regulation from approximate regulation.

Memory, the detail that avoids nasty surprises

After a power cut, the unit recovers its configured values instead of reverting to factory settings. On an installation running unattended, that is what stops you finding an out-of-spec grow room on your return.

A housing built for the load

Passing 16 A through a compact unit calls for construction to match. The manufacturer states a fire-resistant plastic alloy rated for high temperatures — which matters on a device meant to switch heavy loads for long periods.

Technical specifications

• Device type : on/off temperature controller
• Compatible appliances : heaters, fans, air conditioners
• Admissible current : up to 16 A in prolonged operation
• Operating modes : two
• Interface : digital screen with touch buttons
• Memory : values recovered after a power cut
• Sensor : high-precision temperature probe, 5 m cable
• Housing : fire-resistant, high-temperature plastic alloy
• Weight : 0.5 kg
• In the box : 1 controller, 1 sensor with 5 m cable

In the same range

• Cli-mate Humidity Controller Humi – humidistat, 16 A
• Cli-mate Climate Station Total – lighting and full climate, 7 A
• Cli-mate Dual-Flow Controller Twin Humi – humidity, 8 or 24 A

GrowLED tip :
If you are driving a heater, leave a large enough gap between the heating setpoint and the ventilation setpoint: otherwise the two appliances take turns continuously and burn power for nothing. Two to three degrees is usually enough.

Joseph – Directeur de GrowLED